Mounting The Switch On A Rack - ZyXEL Communications XGS1930-38 User Manual

Using a #2 Philips screwdriver, install the M3 flat head screws through the mounting bracket holes into
2
the Switch.
Repeat steps
3
You may now mount the Switch on a rack. Proceed to the next section.
4

2.3.3 Mounting the Switch on a Rack

Position a mounting bracket (that is already attached to the Switch) on one side of the rack, lining up
1
the two screw holes on the bracket with the screw holes on the side of the rack.
Figure 7 Mounting the Switch on a Rack
Using a #2 Philips screwdriver, install the M5 flat head screws through the mounting bracket holes into
2
the rack.
Repeat steps
3
Note: Make sure you tighten all the four screws to prevent the Switch from getting slanted.
Chapter 2 Hardware Installation and Connection
1 and 2 to install the second mounting bracket on the other side of the Switch.
1 and 2 to attach the second mounting bracket on the other side of the rack.
XGS1930 Series User's Guide
27