Save Configuration; Reboot System - ZyXEL Communications XGS1930-38 User Manual

Figure 197 Erase Running-Configuration: Confirmation
In the web configurator, click the Save button in the top of the screen to make the changes take effect.
3
If you want to access the Switch web configurator again, you may need to change the IP address of
your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1).

35.4 Save Configuration

Click Config 1 to save the current configuration settings permanently to Configuration 1 on the Switch.
Click Config 2 to save the current configuration settings permanently to Configuration 2 on the Switch.
Click Custom Default to save the current configuration settings permanently to a custom default file on
the Switch. If configuration changes cause the Switch to behave abnormally, click Custom Default (next
to Reboot System) to have the Switch automatically reboot and restore the saved custom default file.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration changes
to the current configuration.
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.

35.5 Reboot System

Reboot System allows you to restart the Switch without physically turning the power off. It also allows you
to load configuration one (Config 1), configuration two (Config 2), a Custom Default or Factory Default
when you reboot. Follow the steps below to reboot the Switch.
In the Maintenance screen, click a configuration button next to Reboot System to reboot and load that
1
configuration file. The following screen displays.
Figure 198 Reboot System: Confirmation
Chapter 35 Maintenance
XGS1930 Series User's Guide
279