Basic Tlv Setting - ZyXEL Communications XGS1930-38 User Manual

Table 121 Advanced Application > LLDP > LLDP Configuration
LABEL
*
Admin Status
Notification
Apply
Cancel

31.6.1 Basic TLV Setting

Use this screen to configure Basic TLV settings. Click Advanced Application > LLDP > LLDP Configuration
(Click Here) > Basic TLV Setting to display the screen as shown next.
Figure 172 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
Chapter 31 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select whether LLDP transmission and/or reception is allowed on this port.
• Disable - not allowed
• Tx-Only - transmit only
• Rx-Only - receive only
• Tx-Rx - transmit and receive
Select whether LLDP notification is enabled on this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS1930 Series User's Guide
247