ZyXEL Communications XGS1930-38 User Manual page 243

Chapter 31 Link Layer Discovery Protocol (LLDP)
Table 119 Advanced Application > LLDP > LLDP Remote Status > LLDP Remote Port Status Detail (Dot1
and Dot3 TLV)
LABEL DESCRIPTION
Vlan Name TLV This shows the VLAN ID and name for remote device port.
•
•
Protocol The Protocol Identity TLV allows the Switch to advertise the particular protocols that are
Identity TLV
accessible through its port.
Dot3 TLV
MAC PHY The MAC/PHY Configuration/Status TLV advertises the bit-rate and duplex capability of the
Configuration &
sending 802.3 node. It also advertises the current duplex and bit-rating of the sending node.
Status TLV
Lastly, it advertises whether these setting were the result of auto-negotiation during link
initiation or manual override.
•
•
•
•
Link The Link Aggregation TLV indicates whether the link is capable of being aggregated,
Aggregation
whether the link is currently in an aggregation, and if in an aggregation, the port
TLV
identification of the aggregation.
• Aggregation Capability — The current aggregation capability of the port.
• Aggregation Status — The current aggregation status of the port.
• Aggregation Port ID — The aggregation ID of the current port.
Power Via MDI The Power Via MDI TLV allows network management to advertise and discover the MDI
TLV
power support capabilities of the sending port on the remote device.
•
•
•
•
•
•
Max Frame Size This displays the maximum supported frame size in octets.
TLV
VLAN ID
VLAN Name
AN Supported - Displays if the port supports or does not support auto-negotiation.
AN Enabled - The current auto-negotiation status of the port.
AN Advertised Capability - The auto-negotiation capabilities of the port.
Oper MAU Type - The current Medium Attachment Unit (MAU) type of the port
Port Class
MDI Supported
MDI Enabled
Pair Controlable
PSE Power Pairs
Power Class
XGS1930 Series User's Guide
243