Classifier Status; Classifier Configuration - ZyXEL Communications XGS1930-38 User Manual

21.2 Classifier Status

Use this screen to view the classifiers configured on the Switch and how many times the traffic matches
the rules.
Click Advanced Application > Classifier in the navigation panel to display the configuration screen as
shown.
Figure 125 Advanced Application > Classifier
The following table describes the labels in this screen.
Table 78 Advanced Application > Classifier
LABEL
Index
Active
Weight
Name
Match Count
Rule
Clear

21.3 Classifier Configuration

Use the Classifier Configuration screen to define the classifiers. After you define the classifier, you can
specify actions (or policy) to act upon the traffic that matches the rules. To configure policy rules, refer
to Chapter 22 on page
In the Classifier Status screen click Classifier Configuration to display the configuration screen as shown.
Chapter 21 Classifier
DESCRIPTION
This field displays the index number of the rule. Click an index number to edit the rule.
This field displays Yes when the rule is activated and No when it is deactivated.
This field displays the rule's weight. This is to indicate a rule's priority when the match order is set
to manual in the Classifier > Classifier Global Setting screen.
The higher the number, the higher the rule's priority.
This field displays the descriptive name for this rule. This is for identification purpose only.
This field displays the number of times a rule is applied. It displays '-' if the rule does not have
count enabled.
This field displays a summary of the classifier rule's settings.
Select Classifier, enter a classifier rule name and then click Clear to erase the recorded
statistical information for that classifier, or select Any to clear statistics for all classifiers.
183.
XGS1930 Series User's Guide
175