Port Details - ZyXEL Communications XGS1930-38 User Manual

Table 174 Port Status (continued)
LABEL
Link
State
PD
LACP
TxPkts
RxPkts
Errors
Tx kB/s
Rx kB/s
Up Time
Clear Counter

48.1.1 Port Details

Click a number in the Port column in the Port Status screen to display individual port statistics. Use this
screen to check status and detailed performance data about an individual port on the Switch.
Chapter 48 Port Status
DESCRIPTION
This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps, 1000M for 1000Mbps, or
10G for 10 Gbps) and the duplex (F for full duplex or H for half). It also shows the cable type
(Copper or Fiber) for the combo ports. This field displays Down if the port is not connected to any
device.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port. See
131 for more information.
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays STOP.
When LACP (Link Aggregation Control Protocol), STP, and dot1x are in blocking state, it displays
Blocking.
For PoE model(s) only.
This field displays whether or not a powered device (PD) is allowed to receive power from the
Switch on this port.
This fields displays whether LACP (Link Aggregation Control Protocol) has been enabled on the
port.
This field shows the number of transmitted frames on this port.
This field shows the number of received frames on this port.
This field shows the number of received errors on this port.
This field shows the number of kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time in hours, minutes and seconds the port has been up.
Select Port, enter a port number and then click Clear Counter to erase the recorded statistical
information for that port, or select Any to clear statistics for all ports.
XGS1930 Series User's Guide
336
page