ZyXEL Communications XGS1930-38 User Manual page 331

Figure 241 Management > Configure Clone
The following table describes the labels in this screen.
Table 172 Management > Configure Clone
LABEL DESCRIPTION
Source/ Enter the destination port or ports under the Destination label. These are the ports which are going
Destination to have the same attributes as the source port. You can enter individual ports separated by a
comma or a range of ports by using a hyphen. For example, 2, 4, 6 indicates that ports 2, 4 and 6
Port
are the destination ports. 2-6 indicates that ports 2 through 6 are the destination ports.
Basic Setting Select which port settings (you configured in the Basic Setting menus) should be copied to the
destination port(s).
Advanced Select which port settings (you configured in the Advanced Application menus) should be copied
Application to the destination ports.
XGS1930 Series User's Guide
331