ZyXEL Communications XGS1930-38 User Manual page 202

Figure 141 Advanced Application > AAA > AAA Setup
The following table describes the labels in this screen.
Table 94 Advanced Application > AAA > AAA Setup
LABEL DESCRIPTION
Authentication Use this section to specify the methods used to authenticate users accessing the Switch.
Login These fields specify which database the Switch should use (first, second and third) to
authenticate administrator accounts (users for Switch management).
Configure the local user accounts in the Access Control > Logins screen. The RADIUS is a
external server. Before you specify the priority, make sure you have set up the corresponding
database correctly first.
You can specify up to three methods for the Switch to authenticate administrator accounts.
The Switch checks the methods in the order you configure them (first Method 1, and finally
Method 2). You must configure the settings in the Method 1 field. If you want the Switch to
check other sources for administrator accounts, specify them in the Method 2 field.
Select local to have the Switch check the administrator accounts configured in the Access
Control > Logins screen.
Select radius to have the Switch check the administrator accounts configured via your RADIUS
server.
Authorization Use this section to configure authorization settings on the Switch.
Type Set whether the Switch provides the following services to a user.
• Exec: Allow an administrator which logs into the Switch through Telnet or SSH to have a
different access privilege level assigned via the external server.
• Dot1x: Allow an IEEE 802.1x client to have different bandwidth limit or VLAN ID assigned via
the external server.
Active Select this to activate authorization for a specified event types.
Chapter 25 AAA
XGS1930 Series User's Guide
202