Ipv6 Global Setup; Ipv6 Interface Setup - ZyXEL Communications XGS1930-38 User Manual

Table 35 Basic Setting > IPv6 > IPv6 Configuration (continued)
LABEL
IPv6 Router
Discovery
Setup
IPv6 Prefix
Setup
IPv6 Neighbor
Setup
DHCPv6 Client
Setup

8.10.3 IPv6 Global Setup

Use this screen to configure the global IPv6 settings. Click the link next to IPv6 Global Setup in the IPv6
Configuration screen to display the screen as shown next.
Figure 70 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Setup
The following table describes the labels in this screen.
Table 36 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Setup
LABEL
IPv6 Hop Limit
ICMPv6 Rate
Limit Bucket
Size
ICMPv6 Rate
Limit Error
Interval
Apply
Cancel
Clear

8.10.4 IPv6 Interface Setup

Use this screen to turn on or off an IPv6 interface and enable stateless autoconfiguration on it. Click the
link next to IPv6 Interface Setup in the IPv6 Configuration screen to display the screen as shown next.
Chapter 8 Basic Setting
DESCRIPTION
Click the link to go to a screen where you can configure the IPv6 router discovery settings.
Click the link to go to a screen where you can configure the Switch's IPv6 prefix list.
Click the link to go to a screen where you can create a static IPv6 neighbor entry in the Switch's
IPv6 neighbor table.
Click the link to go to a screen where you can configure the Switch DHCP settings.
DESCRIPTION
Specify the maximum number of hops (from 1 to 255) in router advertisements. This is the
maximum number of hops on which an IPv6 packet is allowed to transmit before it is discarded by
an IPv6 router, which is similar to the TTL field in IPv4.
Specify the maximum number of ICMPv6 error messages (from 1 to 200) which are allowed to
transmit in a given time interval. If the bucket is full, subsequent error messages are suppressed.
Specify the time period (from 0 to 2147483647 milliseconds) during which ICMPv6 error messages
of up to the bucket size can be transmitted. 0 means no limit.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the nonvolatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
XGS1930 Series User's Guide
94