Temperature Ice Point Calibration (Init > T.cal > Ice.p); Save Current Configuration For All Parameters To A File (Init > Save); Load A Configuration For All Parameters From A File (Init > Load); Display Firmware Revision Number (Init > Ver.n) - Newport Pt32 Operator's Manual

PLATINUM Series Controllers User's Guide
6.8.4 Temperature Ice Point Calibration (INIt > t.CAL > ICE.P)
Select ICE.P to calibrate the zero point for the temperature sensor. This function basically
operates the same as a 1.PNT offset adjustment restricted to a measurement at the freezing
point of water.
Navigate to the ok? To set the ICE POINT value or DSBL to clear the previous ICE POINT offset.
 Ok? – Offset is calculated, using assumed value of C.

dSbL– Clears the Ice Point offset value
Confirm the Ice Point set or reset.
6.9 Save Current Configuration for All Parameters to a File (INIt > SAVE)
Select Save Current Configuration Settings (SAVE) as the command to execute. If no thumb
drive is present the failure code E010 is displayed. Otherwise, a numeric designation for the
save file is then specified and confirmed before the SAVE command executes.
Important Note: The configuration file is a tab separated text file with a ".TXT" extension. It
can be loaded onto a PC, read into Excel then modified there. Once modified, save it back as
a tab separated .TXT file and it can then be loaded back into the unit using the INIt > LoAd
command. This capability can be especially useful for editing complex multi ramp and soak
programs. For more information on the configuration file format, see the "Load and Save File
Format Manual".
Select a numeric file name from the range 0–99.
Confirm the SAVE command. This saves the configuration to the file number specified. If the
SAVE operation fails, the failure code w004 is displayed. If the SAVE operation is successful,
doNE is displayed.
6.10 Load a Configuration for All Parameters from a File (INIt > LoAd)
Select the Load a Configuration (LoAd) command. If no thumb drive is present the failure code
E010 is displayed. Otherwise, a numeric designation for the file to be loaded is then specified
and confirmed before the LoAd command executes.
Select a numeric file name from the range 0–99.
Confirm the LoAd command. This loads the configuration from the file number specified. If
the LoAd operation fails, the failure code w003 is displayed. If the LoAd operation is
successful, doNE is displayed.
6.11 Display Firmware Revision Number (INIt > VER.N)
Select the Display Firmware Revision Number (VER.N) function. The currently installed version
number is displayed in the format 1.23.4 where "1" is the major revision number, "23" is the
minor revision number, and "4" is the bug fix update number.
Reference Section: Initialization Mode (INIt) 42