Programming Mode Menu (Prog) - Newport Pt32 Operator's Manual

PLATINUM Series Controllers User's Guide

5.2 Programming Mode Menu (PRoG)

The following table maps the Programming Mode (PRoG) navigation:
Level Level Level
2 3 4
SP1 ____
SP2 ASbo
dEVI
ALM.1 Note: This submenu is the same for all other Alarm configurations.
tyPE oFF
AboV
bELo
HI.Lo.
bANd
Ab.dV AbSo
d.SP1
d.SP2
CN.SP
ALR.H ____
ALR.L ____
A.CLR REd
AMbR
GRN
dEFt
HI.HI oFF
oN
LtCH No
yES
botH
RMt
CtCL N.o.
N.C.
A.P.oN yES
No
dE.oN ____
dE.oF ____
oUt2
oUt3
PId.S ACtN RVRS
dRCt
A.to ____
Level Level
5 6
Process goal for PID, default goal for oN.oF
Setpoint 2 value can track SP1, SP2 is an absolute value
SP2 is a deviation value
ALM.1 is not used for display or outputs
Alarm: process value above Alarm trigger
Alarm: process value below Alarm trigger
Alarm: process value outside Alarm triggers
Alarm: process value between Alarm triggers
Absolute Mode; use ALR.H and ALR.L as triggers
Deviation Mode; triggers are deviations from SP1
Deviation Mode; triggers are deviations from SP2
Tracks the Ramp & Soak instantaneous setpoint
Alarm high parameter for trigger calculations
Alarm low parameter for trigger calculations
Red display when Alarm is active
Amber display when Alarm is active
Green display when Alarm is active
Color does not change for Alarm
High High / Low Low Alarm Mode turned off
____ Offset value for active High High / Low Low Mode
Alarm does not latch
Alarm latches until cleared via front panel
Alarm latches, cleared via front panel or digital input
Alarm latches until cleared via digital input
Output activated with Alarm
Output deactivated with Alarm
Alarm active at power on
Alarm inactive at power on
Delay turning off Alarm (sec), default = 1.0
Delay turning off Alarm (sec), default = 0.0
oUt2 is replaced by output type
oUt3 is replaced by output type (1/8 DIN can have up to 6)
Increase to SP1 (i.e., heating)
Decrease to SP1 (i.e., cooling)
Set timeout time for autotune
Complete Menu Structure
Notes
21