Output Channel Mode (Prog > Out1-Out6 > Mode) - Newport Pt32 Operator's Manual

PLATINUM Series Controllers User's Guide
7.4.1 Output Channel Mode (PRoG > oUt1–oUt6 > ModE)
Select Output Channel Mode (ModE) to configure the specified output.
Navigate to the desired setting. Settings include the following:

oFF

PId

oN.oF – Set the output to On/Off Control Mode

ALM.1 – Set the output to be an Alarm using the ALM.1 configuration

ALM.2 – Set the output to be an Alarm using the ALM.2 configuration

RtRN – Set up the output for Retransmission

RE.oN – Turn on the output during Ramp events

SE.oN – Turn on the output during Soak events
Select the indicated setting.
Turn off this output (oFF).
Select PID Control Mode (PId) for this output (factory default). PID parameters are
set outside the specific output submenus, as more than one output can be used for
PID control at a time. See
Select On/Off Control Mode (oN.oF) for this output. More than one output can be
set up for oN.oF control. For Heat / Cool control set the output connected to the
heater with ACtN equal to RVRS and the output connected to the cooling device
with ACtN set to dRCt.
Navigate to the desired setting. Settings include the following:



Select the indicated setting.
– Turn off the output channel (factory default)
– Set the output to Proportional-Integral-Derivative (PID) Control Mode
7.4.1.1 Turn Off Output Channel (PRoG > oUt1–oUt6 >
ModE > oFF)
7.4.1.2 PID Control Mode (PRoG > oUt1–oUt6 > ModE >
PId)
7.5 PID Configuration (PRoG >
7.4.1.3 On/Off Control Mode (PRoG > oUt1–oUt6 >
ModE > oN.oF)
ACtN – Determines the action direction for control
dEAd – Sets the deadband value; the deadband value is applied in the
same units as the process variable to one side of Setpoint as determined by
the ActN direction
S.PNt – Allows either Setpoint 1 or Setpoint 2 to be specified as the
target value; Setpoint 2 can be set to track Setpoint 1 using the deviation
(dEVI) option (7.2 Setpoint 2 (PRoG >
up for heat/cool operation
Reference Section: Programming Mode (PRoG)
PID).
SP2))—a useful feature when setting
50