Changing The Settings - REMEHA Gas 310 ECO PRO-285 Installation, User And Service Manual

Gas 310 ECO PRO - Gas 610 ECO PRO
5.7

Changing the settings

160514 - 125467-05
4 t1 = Flow temperature (°C).
4 t" = Return temperature (°C).
4 t4 = Outside temperature (°C)
Only with an outside temperature sensor (Accessory).
4 t6 = Exchanger temperature (°C).
4 5p = Internal set point (°C).
4 fl = Ionization current (µA).
4 Mf = Fan speed (rpm).
4 pr = Water pressure (bar (MPa)).
Only with the hydraulic pressure sensor connected (Accessory).
4 p; = Supplied relative heat output (%).
4 51 = Pressure switch minimum Gps (Kz = Not connected /
K1 = Gas pressure OK / K" = Gas pressure incorrect)
Only with connected minimum gas pressure switch (Accessory)
4 5" = Gas valve leak proving system Vps (Kz = Not
connected / K1 = No gas leak / K" = Gas leak present)
Only with connected gas leakage control (Accessory).
4 V1 = Analogue input (V).
4 V" = Analogue output (V).
¼See the Installation and service manual HMI GAS 310/610 ECO
PRO for comprehensive operating instructions. This includes
information about changing and reading parameters, the meaning of
fault codes and deleting the failure memory.
The boiler control panel is set for the most common heating
systems. With these settings, practically all heating systems operate
correctly. The user or installer can optimise the parameters according
to own preferences.
¼See the Installation and service manual HMI GAS 310/610 ECO
PRO for comprehensive operating instructions. This includes
information about changing and reading parameters, the meaning of
fault codes and deleting the failure memory.
5. Commissioning
57