Gas Settings - REMEHA Gas 310 ECO PRO-285 Installation, User And Service Manual

Gas 310 ECO PRO - Gas 610 ECO PRO
5.4

Gas settings

160514 - 125467-05
3. The start-up cycle begins and cannot be interrupted. During the
start-up cycle, the display shows the following information:
A short test where all segments of the display are visible.
fK[xx : Software version
pK[xx : Parameter version
The version numbers are displayed alternately.
By pressing the S key for a short time, the current operating status
is shown on the display:
Error during the start-up procedure:
4 No information is shown on the display:
- Check the mains supply voltage
- Check the main fuses
- Check the fuses on the control panel:
(F1 = 2 AT, F2 = 10 AT)
- Check the connection of the mains lead to the connector in the
instrument box
- Check the display flat cable
4 A fault is indicated on the display by the fault symbol c and a
flashing fault code:
- The meaning of the error codes is given in the error table.
- Press for 2 seconds on key J to restart the boiler.
Heat demand Heat demand stopped
1: Fan ON 5: Burner stop
": Boiler is igniting 6: Post-circulation of the pump
3: Heating System 0: Standby
In STAND-BY, the display normally shows the water pressure next to
0 (only when the hydraulic pressure sensor is connected) and the
symbols D and H.
The boiler is preset in the factory to operate on natural gas G20 (Gas
H).
5. Commissioning
53