Checks And Adjustments After Commissioning; Finalizing Work; Reading Out Measured Values; Reading The Various Current Values - REMEHA Gas 310 ECO PRO-285 Installation, User And Service Manual

5. Commissioning
5.5

Checks and adjustments after commissioning

2
1
5.6

Reading out measured values

56
5.5.1.
1. Remove the measuring equipment.
2. Put the flue gas sampling plug back in place.
3. If installed: Check the setting of the minimum gas pressure switch
Gps. The pressure switch must be set at 10 mbar.
4. If installed: Check the setting of the pressure switch for gas
leakage control Vps. The pressure switch must be set at 50 % of
the admission pressure (Up to 40 mbar).
¼ See chapter: "Connection possibilities for the PCB (SCU-
S05)", page 42
T001522-A
5. Reapply the casing on the inspection side.
6. Push key J to return the boiler to normal operating mode.
7. Raise the temperature in the heating system to approximately
70°C.
8. Shut down the boiler.
9. After about 10 minutes, vent the air in the heating system.
10.Switch on the boiler.
11.Checking the hydraulic pressure. If necessary, top up the water
level in the heating system.
12.Tick the gas category used on the data plate.
13.Explain the operation of the installation, the boiler and the
regulator to the users.
14.Give all the instruction manuals to the user. A documentation
folder can be found in the frame of the boiler. Use it to store all
boiler manuals together with other documents relating to the
installation.

15.Finalizing work.

16.Complete the checklist. ¼ See chapter: "Checklist for
commissioning", page 77.
T003979-E
5.6.1.
The following current values can be read off the information menu
Q:
4 5t = State.
4 5v = Sub-status.
Gas 310 ECO PRO - Gas 610 ECO PRO
Finalizing work
The various boiler parameters are preset in the factory.
These factory settings are suitable for the most common
heating systems. For other systems and situations, the
parameters can be modified.

Reading the various current values

160514 - 125467-05