Commissioning; Control Panel; Functions Of The Keys; Meaning Of The Symbols On The Display - REMEHA Gas 310 ECO PRO-285 Installation, User And Service Manual

5. Commissioning

5 Commissioning
5.1

Control panel

ºCºFh
St ºC
barPsi
rpm
kWµA
l/min
± 30
2 3 4 5
6 7
Information menu:
Reading the various current values.
Q
Chimney-sweeping position:
B
Forced full or part load for CO
User menu:
W
Parameters at user level can be changed.
Heating programme deactivated:
C
The heating function is deactivated.
Manual mode:
E
Boiler is set to manual operation.
Service menu:
? Parameters at installer level can be changed.
50
¼See the Installation and service manual HMI GAS 310/610 ECO
PRO for comprehensive operating instructions. This includes
information about changing and reading parameters, the meaning of
fault codes and deleting the failure memory.
5.1.1.
1
1 8
2
3
4
5
6
7
8
9
9
T003479-D
5.1.2.
measurement.
2
Gas 310 ECO PRO - Gas 610 ECO PRO
For operation of the boiler Gas 610 ECO PRO: Each
module has its own instrument panel.

Functions of the keys

Display
> [Escape] or J key
D Heating temperature key or [-]
[+] key
S [Enter] or cancel d Key lock-out
B [Chimney-sweeping] keys
(press the 2 and 3 keys simultaneously)
f [Menu] keys
(press the 4 and 5 keys simultaneously)
On/Off switch
PC connection

Meaning of the symbols on the display

On/Off switch (0/1):
/ After 5 lock-outs, the boiler must be switched off/on
again.
Circulation pump:
b
The pump operates.
Central heating function:
D
Access to central heating temperature parameter.
Locking the keys:
d
Key lock-out is activated.
Yellow display with the symbols:
K
$ + K + Z (Maintenance message).
Water pressure:
e The water pressure is too low. Only with the hydraulic
pressure sensor connected (Accessory).
160514 - 125467-05