Changing Boiler Settings - REMEHA Avanta 12v Users Operation Instructions & Important Warranty Information

Remeha Avanta

3 CHANGING BOILER SETTINGS

R
LT.NL.W6H.000.070
R
1x
LT.NL.W6H.000.071
R
2x
LT.NL.W6H.000.072
62999-130711
1. Changing P1 setting: flow temperature of water in central heating system
Reduce the flow temperature as follows:
• Press [Enter]-key until codes pK and K1 are displayed alternately.
• Press [Enter]-key again; set value for maximum flow temperature is displayed:
75°C (factory setting).
• Press [+] or [-] key to change this value, for example to 70°C.
• Press [Enter]-key to confirm value; codes pK and K1 are displayed
alternately.
• Press [Reset]-key to switch boiler to operating mode.
2. Changing P2 setting: domestic hot water temperature
Increase the domestic hot water temperature as follows:
• Press [Enter]-key until codes pK and K1 are displayed alternately.
• Press '[+]-key until codes pK and K2 are displayed alternately.
• Press [Enter]-key; set value for domestic hot water temperature is displayed:
55°C (= factory setting).
• Press [+] or [-] key to change this value, for example to 65°C.
• Press [Enter]-key to confirm value; codes pK and K2 are displayed
alternately.
• Press [Reset]-key to switch boiler to operating mode.
3. Changing P3 setting: boiler regulation (domestic hot water and central
heating mode)
0 = CH
/ DHW
off
1 = CH
/ DHW
on
2 = CH
/ DHW
on
3 = CH
/ DHW
off
Change the boiler regulation as follows:
• Press [Enter]-key until codes pK and K1 are displayed alternately.
• Press [+]-key 2x until codes pK and K3 are displayed alternately.
• Press [Enter]-key; central heating and domestic hot water mode setting is
displayed.
• Press [-] or [+] key to change this mode, e.g. level 3 (= central heating OFF
and domestic hot water ON).
• Press [Enter]-key to confirm this mode; codes pK and K3 are displayed
alternately.
• Press [Reset]-key to switch boiler to operating mode.
Remeha is a licensed member of the Benchmark Scheme which aims to improve the standards
of installation and commissioning of domestic heating and hot water systems in the UK and to
encourage regular servicing to optimise safety, efficiency and performance.
Benchmark is managed and promoted by the Heating and Hotwater Industry Council.
For more information visit www.centralheating.co.uk
off
(factory setting)
on
off
on
3. Changing boiler settings
5