Checking The Gear Shift Operation - Yamaha F150A Service Manual

CHK
ADJ
5. Operate throttle lever 2 to check that the
throttle valves fully close and fully open.
b
8
NOTE:
The throttle valves are fully open when the
throttle cam roller 8 is within the range b
shown in the illustration.
6. Contact the stopper 4 on the throttle
lever 2 to the fully closed stopper 5 on
the cylinder block and check that throttle
cam roller 8 is aligned with the align-
ment mark c.
8
4
5
7. Adjust the position of the throttle cable
joint until its hole is aligned with the set
pin on throttle lever 2.
3-11
Periodic checks and adjustments
S63P3240
c
S63P3250
d
CAUTION:
The throttle cable joint must be screwed
in a minimum of 8.0 mm (0.31 in) d.
8. Connect the cable joint, install the clip,
and then tighten the locknut.
9. Check the throttle cable for smooth oper-
ation and, if necessary, repeat steps 1–8.

Checking the gear shift operation

1. Check that the gear shift operates
smoothly when shifting it from neutral to
forward or reverse. Adjust the shift cable
length if necessary.
2. Set the gear shift to the neutral position.
3. Loosen the locknut 1, remove the clip
2, and then disconnect the shift cable
joint 3.
2
4. Adjust the position of the shift lever until
the pin on the lever is aligned with the
line on the shift position switch plate 4.
5. Align the center of the set pin a with the
alignment mark b on the bottom cowl-
ing.
S63P3210
3
1
4
S63P3260
63P3F11