Checking The Gear Shift Operation - Yamaha F50F Service Manual

e
e
10. Adjust the position of the throttle cable
joint until its hole is aligned with the set
pin.
f
NOTE:
Pull the throttle cable towards the set pin to
remove any free play in the cable before
adjusting the position of the throttle cable
joint.
11. Connect the throttle cable joint, install the
clip, and then tighten the locknut.
WARNING
The throttle cable joint must be screwed
in a minimum of 8.0 mm (0.31 in) f.
6C13G11
d
8
d
S6C13170
S6C13180
12. Operate the throttle to check that the
throttle valves fully close and fully open,
and check that the throttle cam contacts
the fully closed stopper when the throttle
is in the fully closed position.
13. Check the throttle cable for smooth oper-
ation and, if necessary, repeat steps 1–
12.

Checking the gear shift operation

1. Check that the gear shift operates
smoothly when shifting it from neutral to
forward or reverse. Adjust the shift cable
length if necessary.
2. Set the gear shift to the neutral position.
3. Loosen the locknut 1, remove the clip
2, and then disconnect the shift cable
joint 3.
2
4. Align the center of the set pin a with the
alignment mark b on the bracket.
a
b
Control system
3
1
S6C13190
S6C13200
3-12
1
2
3
4
5
6
7
8
9