Removing The Hydro Tilt Assembly; Checking The Hydro Tilt; Checking The Hydro Tilt Anode; Installing The Hydro Tilt Assembly - Yamaha F30B 2018 Service Manual

Removing the hydro tilt assembly

When removing the hydro tilt assembly
with the power unit installed, make sure to
suspend the outboard motor.
TIP:
Fully tilt the swivel bracket up, and then sup-
port it using the tilt support knob "1".

Checking the hydro tilt

1. Check:
• Hydro tilt unit
Damage/gas leakage/oil leakage/bent 
Replace.
• Do not disassemble or puncture the hydro
tilt unit, as high-pressure gas is con-
tained.
• Do not apply heat or fire to the hydro tilt
unit, as high-pressure gas is contained.

Checking the hydro tilt anode

1. Check:
• Anode
Eroded (1/2 or more)  Replace.
There is grease, oil, or scales.  Clean.
Do not apply grease, oil, or paint to the an-
ode.

Installing the hydro tilt assembly

1. Install:
1
9-25
• Anode
• Bushing (to the hydro tilt, clamp bracket,
and swivel bracket)
• Tilt lock lever
• Tilt lock lever cap
• Hydro tilt unit
• Shaft (upper side)
• E-clip
• Collar
• Shaft (lower side)
Hydro tilt