Installation Of Extension Modules (Extension Cable Type); Installation Of Terminal Modules; Removal Of Cpu Module - Mitsubishi Electric FX5UC-96MT/D User Manual

Installation of extension modules (extension cable type)

1.
Push out the DIN rail mounting hook (A in the right figure) of the
extension module (extension cable type).
2.
Fit the upper edge of the DIN rail mounting groove (B in the right
figure) onto the DIN rail.
3.
Push the product against the DIN rail.
4.
Lock the DIN rail mounting hooks while pressing the product
against the DIN rail.
5.
Connect the extension cable. For the connecting procedure of the extension cables, refer to Page 82 Connecting
Methods for CPU Module and Extension Devices.

Installation of terminal modules

1.
Turn off all the power supplies connected to the CPU module,
extension modules, or terminal modules.
2.
Fit the upper edge of the DIN rail mounting groove (A in the right
figure) onto the DIN rail.
3.
Push the product against the DIN rail.

Removal of CPU module

1.
Remove the connection cables including power cables and I/O
cables.
2.
Insert the tip of a flathead screwdriver into the hole of the DIN rail
mounting hook (B in the right figure). This step also applies for
the DIN rail mounting hooks of the expansion adapters or
extension modules (connector type).
3.
Move the flathead screwdriver as shown in the right figure to
draw out the DIN rail mounting hooks of all devices.
4.
Remove the product from the DIN rail (C in the right figure).
5.
Push in the DIN rail mounting hooks (D in the right figure).
Back side
1
A
B
3
A
3
C
B
2
5
D
5.3 Procedures for Installing on and Detaching from DIN Rail
4
3
5 INSTALLATION
79
5