Hole Pitches When Extension Module Connected; Installation Of Extension Module (Extension Cable Type) - Mitsubishi Electric FX5UC-96MT/D User Manual

Hole pitches when extension module connected

Ex.
30 14
C
A
2 *1 2 *1
FX5-CNV-BUS
FX5-16EX/ES FX3U-1PG
*1 The gap between products is 2 mm.

Installation of extension module (extension cable type)

1.
Make mounting holes on the mounting surface
according to the external dimensions diagram.
2.
Push in the DIN rail mounting hook (A in the right figure)
of the extension module (extension cable type). If the
DIN rail mounting hook is not pushed in, the screw hole
is covered, and the extension module cannot be
mounted. (This procedure may not be required,
depending on the model.)
3.
Fit the extension module (extension cable type) (B in the
right figure) to the holes, and secure it with M4 screws
(C in the right figure).
Unit: mm
Rear panel
2
C
Rear panel
A
B
C
5.4 Procedures for Installing Directly (with M4 Screws)
5
5 INSTALLATION
81