Mitsubishi Electric FX5UC-96MT/D User Manual page 90

• Terminal module
I/O cable
■Preparation of I/O connectors
• Suitable connector (commercial item)
Use 20-pin (1-key) sockets conforming to MIL-C-83503.
Check that the sockets do not interfere with peripheral parts including connector covers in advance.
• I/O cables (Mitsubishi option)
I/O cables on which connectors are attached are prepared.
Model
FX-16E-500CAB-S
FX-16E-150CAB
FX-16E-300CAB
FX-16E-500CAB
FX-16E-150CAB-R
FX-16E-300CAB-R
FX-16E-500CAB-R
• Connectors for self-making I/O cables (Mitsubishi option)
Prepare wires and crimp tools by users.
Model and configuration of I/O connectors
Mitsubishi model
FX2C-I/O-CON for flat cables
FX2C-I/O-CON-S for single wires
FX2C-I/O-CON-SA for single wires
Contact for crimp tools: Fujikura Ltd.
• Certified connectors (commercially available connectors)
Connectors made by DDK Ltd. shown above
5 INSTALLATION
88
5.5 Connecting Methods for CPU Module and Extension Devices
Terminal module
Length Description
5 m General-purpose I/O cable
1.5 m Cables for connection of the
terminal module and I/O connectors
3 m
For the connection with the terminal
5 m
module, refer to Page 89
1.5 m WIRING.
3 m
5 m
Part description
(Manufactured by DDK Ltd.)
10 sets Crimp connector FRC2-A020-30S
5 sets Housing HU-200S2-001
Crimp contact HU-411S
5 sets Housing HU-200S2-001
Crimp contact HU-411SA
Type
• Single wire (Wire color: Red)
• CPU module side: 20-pin connector is attached.
• Flat cables (with tube)
• On both ends, 20-pin connectors are attached.
• Round multicore cables
• On both ends, 20-pin connectors are attached.
Suitable wiring (UL-1061-compliant products are
recommended) and tool
Wire size Crimp tool
(Manufactured by DDK Ltd.)
2
AWG 28 (0.1 mm ) 357J-4674D main body
1.27-pitch 20 cores 357J-4664N attachment
2
AWG 22 (0.3 mm ) 357J-5538
2
AWG 20 (0.5 mm ) 357J-13963