Throttle & Brake Pedal; A-Arms; Steering Knuckle Support; Tie Rod - Carter Talon 150 FX Series Service Manual

THROTTLE & BRAKE PEDAL
• Remove Throttle, Throttle Pedal and Axle Nut, check for signs of wear,
replace if wear is present.
• Fill with grease in order to make the Throttle & Brake Pedal swing more
fexible before installation.

A-ARMS

Grease the nipples of Upper & Lower A-Arm, FR.
Wheel periodically
Removal Bolt of Upper & Lower A-Arm, FR. Wheel
Check the Nylon Bushing of Upper & Lower A-Arm, FR Wheel
for wear, replace them immediately if wear is present.

STEERING KNUCKLE SUPPORT

Remove Rubber Dust Cover of the knuckle Support
Check the grease of Ball Joint. Clean it if its dirty and filled with grease
Replace the Steering Knuckle support if the Ball Joint is loose or steering
isn't flexible

TIE ROD

Tie rods should be checked for ease of movement in their full rotation.
Remove protective boot and apply grease.
Check tie rod ends periodically for tightness at their adjusting nuts.
Always use a new cotter pin after removal.
REVERSE ADJUSTMENT
1. Press down the reverse lever to the "FW" position so that the units can move forward, pull back
the level to "BW" so that the units can move backward.
2. Adjusting Nut #1 on the top of the reverse gear box, in the forward position there should be
about 1/4 inch play in the cable for the correct adjustment.
69