Trigger Winding; Cdi Component; Remove The Cdi Component - Carter Talon 150 FX Series Service Manual

TRIGGER WINDING

• Remove the connector of the trigger winding wire.
• Measure the resistance value between the trigger winding (green/red wire) and the body ground
wire.
When the actual value is more than the standard value, it should be replaced.

CDI COMPONENT

It is similar to the regular inspection, the CDI component inspection
is also divided into two steps: First inspect every wiring, winding or
coil connected with CDI, then inspect the CDI component.

REMOVE THE CDI COMPONENT.

• Check to see if the connector is loose or eroded.
• Inspect the conduction and the resistance value of the main switch, the ignition charging coil,
the trigger winding, and the ignition coil. When the main switch is in "OFF" position, it should be
conducted, and the resistance value of every coil should be the standard value.
• Inspect the resistance value between every CDI component terminal. If the actual value is not in
the range of the value in the chart, then the CDI component is faulty.
CDI COMPONENT
SW (B/W)
EXT (B/R)
PC (G/R)
E (G or G/W)`
IGN (B/Y)
B- Black
The CDI component can also be inspected and measured with the CDI testing instrument.
Please carefully read the instrument specification to know how to properly operate.
• Connect CDI component with the special wire of the testing instrument.
• Observe the spark condition on the instrument when the switch is turned on different positions
(OFF, P, EXT, ON1, ON2)
Standard Value
SW (B/W) EXT (B/R)
100 ~ ∞
0.5 ~ 50
10 ~ 1000 10 ~ 1000
0.5 ~ 50 0.5 ~ 50
∞ ∞
W- White
40 ~300 Ω(20°C)
PC (G/R)
50 ~ ∞
100 ~ ∞
1 ~ 10
∞
R-Red G-Green
64
E (G or G/W) IGN (B/Y)
100 ~ ∞ ∞
∞ ∞
1 ~ 100 ∞
∞
∞
Y- Yellow