DRIVEN PLATE BEARING REPLACEMENT
If the driven plate needle bearing or the ball bearing are loose,
damaged, or make unusual sounds, they should be replaced.
• Remove the needle bearing from the driven plate.
The removed bearing cannot be reused.
• Remove the circlip from the driven plate.
• Drive the ball bearing out.
The removed bearing cannot be reused.
• Apply some grease on the new ball bearing.
• Drive the ball bearing into the driven plate with its front face upwards.
• Mount the circlip.
• Apply grease evenly on the inner wall of the driven plate.
Use the prescribed grease.
• Drive in the new needle bearing with its mark upwards.
• Apply grease around the bearing.
Use the specific tool.
49