Clutch Installation - Carter Talon 150 FX Series Service Manual

• Remove the clutch friction plate.
• Remove the whole set of clutch/driven plate.
• Compress the driven pulley spring with the clutch spring
compressor, and at the same time remove the nut on the
shaft.
• Disassemble the clutch with the driven pulley.
• Remove the circlip, and remove the connecting piece.
• Remove the clutch centrifugal weight set and the spring.

CLUTCH INSTALLATION

• Mount the clutch damper rubber onto the drive plate pin.
• Mount the new clutch weight set and spring on the drive plate.
• Install the connecting piece, the circlip, and the bottom plate.
• Finally reverse the removal procedure for installation.
When assembling the clutch and the driven plate, you must use a clutch spring
compressor, or it will damage the spring. No grease on the driven pulley.
47