Clutch; Clutch Removal; Clutch Inspection; Clutch Disassembling - Carter Talon 150 FX Series Service Manual

• Enlarge the driven plate belt groove, and mount on the driven belt.
Mount the other end of the driven belt on the drive plate hub.
• Mount the drive plate, the drive plate washer, and nut.
• Hold the drive plate with a multiuse holder to make it unmovable.
• At the same time fasten the nut on the shaft.
Do not allow any grease or oil to get on the surface of the
movable drive plate and the driven belt.

CLUTCH REMOVAL

• Remove the left crankcase cover.
• Remove the drive plate and the driven belt.
• Hold the clutch friction plate with a multiuse holder,
and remove the nut.
• Remove the clutch friction plate.

CLUTCH INSPECTION

• Inspect if there is any abrasion or damage on the clutch friction plate.
• Measure the inner diameter of the clutch friction plate.
Service Limit
• Inspect if there is any abrasion or damage of the clutch centrifugal
weigh friction piece.
• Measure the thickness of the clutch centrifugal weight friction
piece.
Service Limit

CLUTCH DISASSEMBLING

• If the centrifugal weight set needs to be replaced, you must
disassemble the clutch.
When the friction piece is worn, it should be replaced
with the centrifugal weight set.

CLUTCH

125.5mm
1.5mm
46