Driven Belt Pulley Installation; Transmission Belt; Transmission Belt Inspection - Carter Talon 150 FX Series Service Manual

DRIVEN BELT PULLEY INSTALLATION

• Remove the grease on the driven plate.
• Mount the oil seal.
• Apply a little grease on the O-ring.
• Mount the movable driven plate into the driven plate.
• After applying some grease on the roller, the guide pin, mount
them into the driven plate hole.
• Install the oil seal collar.
• Remove the excessive grease.
Do not get grease on the movable faces of
the driven plate.
• Assemble with the clutch and install on the left crankcase.

TRANSMISSION BELT

TRANSMISSION BELT INSPECTION

• Remove the left crankcase cover.
• Inspect if the transmission belt is chapped or worn.
• Measure the width of the belt.
Service Limit
• Replace the belt if its width is less than the above limit.
When replacing, you must use the OEM part for correct fit.
See the drive pulley removal and installation procedure for the
replacement.
19.0mm
50