Sam Sirius 840 User Manual page 338

Sirius 800 Series User Manual
C.4.3.7 5925 Output Module LED Information
Table 107 shows the LED color code on the 5925 output module, and Figure 215 shows the
front edge of the output module.
LED Color Label
Table 107 5925 Sirius 800 Video AHP Output Module LED Information
Iss 5 Rev 7
Detail
Red
1
Green
Red
2
Green
Red
3
Green
Red
4
Green
Green Power OK Power to the module
Local Receiving messages
Command from local Nucleus
Yellow OK control module (the
Nucleus controller in
this frame)
Local Error with messages
Command from local Nucleus
Error control module (the
Nucleus controller in
this frame)
Red
Output Modules Modules No Longer Supplied With New Systems C.4
Normal Working Status
Each Pair of FPGA LEDS:
Flashing rapidly between Red &
FPGA 1 status
Green (2 Hz each LED) - starting up
Green On Solid & Red Off - normal
state working correctly
Green Off & Red On Solid - FPGA
programming fault found. Remove
module and refit to force a reboot.
FPGA 2 status
Red & Green Flashing very rapidly in
sync (4 Hz each LED) - A change has
been made to the module settings
database in RAM but it has not yet been
written to flash memory. This is not a
fault and the flash memory will be
FPGA 3 status updated after 10 seconds of no audio
setting changes being made. Do not
remove power from the module while
this indication is present as the flash
may become corrupted.
Other indications are displayed when
FPGA 4 status
performing a firmware upgrade, see the
Sirius 800 Maintenance & Upgrade
manual for details.
On Solid - working correctly
Flashing - receiving information and
working correctly
Off - normal state
Flashing - the command message from
the router controller is corrupt or hasn't
been received.
This communications error could be
caused by a hardware failure or
incorrect insertion. Check that the
module is inserted correctly.
If the "Local Command Error" LED is
flashing at the same time as the "Local
Command OK" LED is flashing it
suggests a mismatch in the
configuration of the Nucleus controller.
Check the controller configuration.
Page 338 © 2017 SAM