Sam Sirius 840 User Manual page 192

Sirius 800 Series User Manual
1080i60 - set to Lock to Input so a 1080i60 signal will use delay settings in the 1080i Delay
tab.
Function
XXXX Delay tab (where XXXX is the video standard, eg 1080i Delay)
Video standard configuration tabs for Delay
Frame Offset*
Line Offset*
Pixel Offset*
Delay ms*
*When setting any one of the above values the other settings will automatically change to
reflect the setting being made.
Reference
Input Loss behavior
Table 46
11.3.1.2 16 Channel Mixer
There are 16 Mixers available per video output channel and each mixer can mix up to 16
channels of audio. Each 16 channel mixer is used to mix two or more audio output channels
together to create a single mono signal that is output from the mixer.
The mixing process is purely additive and the gain of the mixed signal will need to be reduced
to ensure it has the correct gain level.
11.3.1.3 Channel Swap (Shuffle)
The channel shuffler is used to change the channel order of one or more of the audio
channels
11.3.1.4 Gain control and Phase Invert
Gain
Gain is applied to an audio output channel as Silence (mute) or in steps of 0.1dB in a range of
-72 dB to +30 dB.
Phase Invert
Phase invert will invert the audio waveform.
11.3.1.5 Embedded Audio Delay
Embedded audio delay is applied to an audio input channel in steps of 0.25 ms in a range of
0 to
Iss 5 Rev 7
5949 Video Embedding & AHP Output with Delay & Sync
Function Description
Select the number of frames of video delay. Only available if Sync
Function is selected as Frame.
If Line is selected then the frame slider is not visible.
Select the number of lines of video delay. Only available if Sync
Function is selected as Frame.
If Line is selected then the frame slider is not visible.
Select the number of pixels of video delay.
Select the video delay in milliseconds.
Lock to Input- Select Lock to Input to enable video delay for the
video standard.
Reference 1 to 4 - Not used for Delay.
Freeze Frame - in the event of input signal loss the last good frame is
output.
Black Screen - in the event of input signal loss a black screen is
output.
Video Delay Configuration
5.46 Seconds.
Page 192
Output Modules and Rear Panels 11.3
© 2017 SAM