Sirius 800 Series User Manual
C.4.1.5 Audio Processing on the Output Module
The 4925 audio output module can manipulate the audio channels received from the audio
crosspoint before outputting them. This makes it possible to manipulate the audio output
channels within the router.
Note:
Audio processing is controlled from Workbench, RollCall or RollPod panels.
Figure 208 and Figure 209 shows the order that the processing is applied to the audio
signals.
Iss 5 Rev 7
The audio processing functions allow gain control, phase invert and stereo mode (left/right
swap, left both, right both or mono mix). The audio processing is standard for each audio
module.
*Input/Output Monitoring selected from either the input or the output of the module
(pre or post processing). See section 5.6.3 for details on how to configure this using
the router Door screen.
Figure 208 Audio Channel Processing Block Diagram (AES Rear Panel)
*Input/Output Monitoring selected from either the input or the output of the module
(pre or post processing). See section 5.6.3 for details on how to configure this using
the router Door screen.
Figure 209 Audio Channel Processing Block Diagram (MADI Rear Panel)
Output Modules
Modules No Longer Supplied With New Systems C.4
Page 327
© 2017 SAM