Table of Contents
Advertisement
Sirius 800 Series User Manual
To select the audio tracks for embedding on video source 99:
Note:
Iss 5 Rev 7
5919 Sirius 800 Video AHP Input Module with Delay and Sync
1.
From the Embedded I/P column on the right of the screen click on the Video 99
button.
2.
The currently configured audio channels are displayed in the In Use column.
3.
Click the Track Preset button once so that it goes yellow, this allows the input
embedding audio tracks to be set one at a time.
Clicking on the Track Preset changes its state in the following sequence:
•
Grey (not selected) - Selecting a video source displays all 16 tracks in the Preset
column. The Preset column is cleared when the Take button is clicked.
•
Yellow (first click) - Selecting a video source leaves the Preset column empty and
allows individual tracks to be selected. The Preset column is cleared when the
Take button is clicked.
•
Yellow + Yellow frame (second click) - Selecting a video source leaves the Preset
column empty and allows individual tracks to be selected. The Preset column is not
cleared when the Take button is clicked.
•
Clicking on the Track Preset button a third time cycles the button state back to
Grey.
4.
From the Sources column on the left of the screen click on the Video Source 2
button.
a
Click on the Channel 1 button in the Preset column.
b
Click on the Channel 5 button in the column between the Source and Preset
columns to direct audio channel 5 to audio channel 1 of video source 99.
c
Click on the Channel 2 button in the Preset column.
d
Click on the Channel 6 button in the column between the Source and Preset
columns to direct audio channel 6 to audio channel 2 of video source 99.
e
Repeat to direct audio channels 9 and 10 to audio channels 3 and 4 of video
source 99.
5.
Click on the Video Source 6 button.
a
Click on the Channel 7 button in the Preset column.
b
Click on the Channel 1 button between the Source and Preset columns to direct
audio channel 1 to audio channel 7 of video source 99.
c
Repeat to direct audio channel 2 to audio channel 8 of video source 99.
6.
Any channels that are not changed will keep their previously set routes.
7.
Click on the Take button to enter the audio package settings.
8.
Click on the Xpt radio button for channels 1 to 4 and 7 to 8 to set the default audio
path. The path will change instantly as each radio button is selected.
These selections can be changed later in the Video AHP Input Audio Processing
screen if required.
A green frame around the In Use channel indicates Xpt is selected for that channel.
9.
Select the Proc radio button for channels 5, 6 and 9 to 16 so they use the original
embedded audio of video source 99. The path will change instantly as each radio
button is selected.
These selections can be changed later in the Video AHP Input Audio Processing
screen if required.
A red frame around the In Use channel indicates Proc is selected for that channel.
10. The package has now been configured for video source 99 and can be modified from
the Video AHP Input Audio Processing screen (see section 9.19.2.4).
11. Click on the menu button to return to the Main Menu screen.
Page 153
Input Rear Panels and Input
© 2017 SAM
Advertisement
Table of Contents
