Sam Sirius 840 User Manual page 278

Sirius 800 Series User Manual
[SNMP]
Version=Version
Description Text
Contact=Unknown
Location=Unknown
SysName=2450
NumberCommunityGet
Names=1
NumberCommunitySet
Names=1
TrapManager=1
TrapManagerAddrN=172.
31.7.133
CommunityGetName
N=public
CommunitySetName
N=private
EnableSnellTraps=1
Iss 5 Rev 7
Nucleus 2450 Router Controller Card
The "Version" variable is the text that is returned when the
sysDescr SNMP request (.1.3.6.1.2.1.1.1) is received by the
card.
The "Contact" variable is the text that is returned when the
sysContact SNMP request (.1.3.6.1.2.1.1.4) is received by the
card. This can be set to the name and/or contact details
responsible for this equipment.
The "Location" variable is the text that is returned when the
sysLocation SNMP request (.1.3.6.1.2.1.1.6) is received by the
card. This can be set to the physical location of the equipment in
the facility.
The "SysName" variable is the text that is returned when the
SysName SNMP request (.1.3.6.1.2.1.1.5) is received by the
card. This can be set to the name by which the equipment is
locally referred to.
The "NumberCommunityGetNames" variable is used to specify
how many community get names are listed in the ini file using
the CommunityGetNameN variable. Up to 2 community strings
of up to 20 characters in length can be specified for get
operations. This is typically set to 1.
The "NumberCommunitySetNames" variable is used to specify
how many community get names are listed in the ini file using
the CommunitySetNameN variable. Up to 2 community strings
of up to 20 characters in length can be specified for set
operations. This is typically set to 1.
The "TrapManager" variable is used to specify how many trap
manager addresses are listed in the ini file using the
TrapManagerAddrN variable. Up to 10 trap manager addresses
can be specified. Any more than this is ignored. This is typically
set to 1.
The "TrapManagerAddrN" variable is used to specify the IP
address for trap managers. The N should be replaced by the
number of the trap manager (1-10).
The "CommunityGetNameN" variable is used to specify 1 of the
community strings used for get operations. The N should be
replaced by a unique digit (either 1 or 2).
The "CommunitySetNameN" variable is used to specify 1 of the
community strings used for set operations. The N should be
replaced by a unique digit (either 1 or 2).
The "EnableSnellTraps" variable is used to specify whether
traps are sent for changes to certain SAM specific variables. If
this is set to 0 MIBv2 system traps are sent, but no SAM specific
traps (for example, routed source change) are sent.
Page 278
Nucleus Router Control Modules 14.5
© 2017 SAM