Table of Contents
Advertisement
Sirius 800 Series User Manual
SRC straight through mode
Note:
Example SRC straight through mode (AES)
SRC settings required for SRC straight through mode for one or more of a group of eight AES
pairs (See Figure 115 on page 178 for setting locations):
SRC Rate: Any
SRC Reference: Disabled
SRC Enable: Checked
Use SRC: Unchecked for the pair(s) required to work in SRC straight through mode
Example SRC straight through mode (MADI)
SRC settings required for straight through mode for a MADI stream
(See Figure 116 on page 178 for setting locations):
SRC Rate: Any
SRC Reference: Disabled
SRC Enable: Checked
Use SRC: Unchecked
Iss 5 Rev 7
4929 Sirius 800 Audio AES/MADI Output with Audio Delay
•
If an AES pair doesn't have sample rate conversion enabled (Use SRC unchecked)
and doesn't have a reference selected (Reference Disabled) then that pair will be
output at the same sample rate as the left channel of the pair. In the case of a MADI
stream all of the pairs will be output at the same sample rate as the first active
channel of the MADI stream.
•
The maximum sample rate that can be input to the SRC in straight through mode is
50 kHz.
•
AES - If channels within a pair are asynchronous to each other then sample drop or
repeat is used on the right channel to match the left channel.
•
MADI - If channels from the audio crosspoint are asynchronous to each other then
sample drop or repeat is used on all channels to match the first active channel in
the MADI stream.
Page 180
Output Modules and Rear Panels 11.1
© 2017 SAM
Advertisement
Table of Contents
