Table of Contents
Advertisement
Sirius 800 Series User Manual
9.19.2.4 Using Input Embedding and AHP
Once a video source input embedding routing has been setup (see section 9.19.2.2) the
audio channels can be controlled and audio processing can be carried out using the Input
Embedding control screen.
Iss 5 Rev 7
5919 Sirius 800 Video AHP Input Module with Delay and Sync
1.
Click on the Video AHP Input Embedding Audio Processing button from the
Workbench Main Menu screen.
2.
The Input Embedding Control screen AHP settings work in the same way as a normal
Workbench AHP screen, see the Workbench user manual for details.
3.
Dial up video source 99 in the usual way.
4.
The shuffle settings reflect any Xpt and Proc radio button selections made in Video
Input Embedding Routing screen.
5.
Each channel can be selected as one of the following options:
•
Crosspoint - selects the channel configured in the Input Embedding Routing
screen (see section 9.19.2.2).
In this mode the 16 channel mixer is bypassed.
•
Processed - selects the original embedded audio channel and any processing
applied to it.
•
Mixer - allows mixing of pre and post processing embedded audio. Crosspoint
audio is not supported by the mixer.
•
Silence - bypasses all of the processing modules and outputs silence on the
audio channel.
Figure 106 Video AHP Input Embedding Audio Processing Screen
6.
For this example shuffling is used to route original embedded audio channels 1 and 2
of video source 99 to channels 5 and 6 of video source 99.
Shuffler Settings:
Channel 5 -click on the Processed button and then radio button 1 on the shuffler.
Channel 6 - click on the Processed button and then radio button 2 on the shuffler.
Page 154
Input Rear Panels and Input
© 2017 SAM
Advertisement
Table of Contents
