Table of Contents
Advertisement
Sirius 800 Series User Manual
LED Color Label
Table 24
Iss 5 Rev 7
4915 Sirius 800 AES/MADI Input Module
Remote
Command
OK
Yellow
Remote
Error
Red
4915 Input Module LED Information
Figure 94 4915 Input Module LEDs
Detail
Receiving messages
from remote Nucleus
control module (the
Nucleus controller in the
frame linked to this
frame)
Error with messages
from remote Nucleus
control module (the
Nucleus controller in the
frame linked to this
frame)
Fugue Status
LED R
LED G
Power OK
Local Command OK
Local Error
Remote Command OK
Remote Error
Page 139
Input Rear Panels and Input Modules 9.17
Status
Sirius 830/840/850 (no expansion):
Off - Expansion not used.
Sirius 850 (expanded to second frame):
Flashing - receiving information and
working correctly
Sirius 830/840/850 (no expansion):
Off - Expansion not used.
Sirius 850 (expanded to second frame):
Off - normal state,
Flashing - the command message from
the remote router controller is corrupt or
hasn't been received.
This communications error could be
caused by a hardware failure or incorrect
insertion. Check that the module is
inserted correctly and the four RJ45
connections between the frames are fitted
correctly (see section 12.2).
If the "Remote Error" LED is flashing at the
same time as the "Remote Command OK"
LED is flashing it suggests a mismatch in
the configuration of the Nucleus controller.
Check the controller configuration.
© 2017 SAM
Advertisement
Table of Contents
