Sam Sirius 840 User Manual page 329

Sirius 800 Series User Manual
C.4.1.9 4925 Output Module LED Information
Table 103 shows the LED color code on the 4925 output module, and Figure 210 shows the
front edge of the output module.
LED Color Label
Blue/Green
Green
Table 103 4925 Sirius 800 AES/MADI Output Module (no audio delay) LED Information
Iss 5 Rev 7
Detail
Fugue CPU status
Status
Red LED R
LED G
Green Power OK Power to the module
Command Receiving messages
OK from local Nucleus
Yellow control module (the
Nucleus controller in
this frame)
Error Error with messages
from local Nucleus
control module (the
Nucleus controller in
this frame)
Red
Output Modules Modules No Longer Supplied With New Systems C.4
Normal Working Status
Flashing sequence Green, Green,
Blue - normal operation the CPU is
programmed and running
Brief Red Flash at startup - normal
Flashing Red - CPU Error. Remove
module and refit to force a reboot.
Flashing rapidly between Red &
Green (2 Hz each LED) - starting up
Green On Solid & Red Off - normal
state working correctly
Green Off & Red On Solid - FPGA
programming fault found. Remove
module and refit to force a reboot.
Red & Green Flashing very rapidly in
sync (4 Hz each LED) - A change has
been made to the module settings
database in RAM but it has not yet been
FPGA status
written to flash memory. This is not a
fault and the flash memory will be
updated after 10 seconds of no audio
setting changes being made. Do not
remove power from the module while
this indication is present as the flash
may become corrupted.
Other indications are displayed when
performing a firmware upgrade, see the
Sirius 800 Maintenance & Upgrade
manual for details.
On Solid - working correctly
Flashing - receiving information and
working correctly
Off - normal state
Flashing - the command message from
the router controller is corrupt or hasn't
been received.
This communications error could be
caused by a hardware failure or
incorrect insertion. Check that the
module is inserted correctly.
If the "Error" LED is flashing at the same
time as the "Command OK" LED is
flashing it suggests a mismatch in the
configuration of the Nucleus controller.
Check the controller configuration.
Page 329 © 2017 SAM