Nucleus 2450: Config.ini File - Sam Sirius 840 User Manual

Sirius 800 Series User Manual
Sirius 850 frame two of two (Frame ID Switch set to 2 - see section 16.3.1)
Table 78 shows the Sirius 850 crosspoint address mapping for Frame 2 of 2:
(using 5928 expansion modules &
Table 78
Note:

14.5.3 Nucleus 2450: Config.ini File

The Nucleus configuration details can be found in the Config.ini file which is on the Compact
Flash memory card. The Config.ini file stores configuration details such as; Test Mode,
switching delay, SW-P-02 over IP settings, etc. See the Workbench user manual for full
details of the Config.ini file.
The following entries are required in the Config.ini file:
[DEBUG]
TestMode=0
[ROUTING]
Set_Delay=-1
[CONFIG]
ResetAfterConfigPush=1
Iss 5 Rev 7
Video Inputs
Main Video Outputs
1365/1290 expansion output
rear panels)
*Multiviewer Outputs
(using two 1291 multiviewer
rear panels)
Monitoring Outputs
Destinations 1 to 576 are not used and do not respond to any control
Sirius 850: Input Output Port Mapping (Frame 2 0f 2)
*Multiviewer Outputs: 1292 to 1431 only if two 1292 multiviewer MV-Link rear panels are
fitted - (no longer supplied)
Nucleus 2450 Router Controller Card
Input/Output Range
1 to 1152
577 to 1152
1 to 96
1 to 4
SAM internal testing use only.
Must be set to "=0" for router control.
The Nucleus router control module will not be able to control
the router if TestMode is set to any other value.
A delay in milliseconds before setting a crosspoint following
the first crosspoint received. The default is -1 (disabled). The
purpose is to ensure multiple crosspoints, sent serially, are
set on a single frame boundary. For example, if an external
controller is setting two crosspoints serially using general
switcher protocol, and the external controller cannot tell
where in the frame it is sending the messages, it is possible
for one crosspoint to go on one frame, and the second on
the next, if the serial commands straddled a frame. By
configuring a Set Delay of two milliseconds (the time to send
the second crosspoint), both crosspoints will have been
received when they are set. That way both crosspoints will
go on the same frame.
Configure the action to be taken after a configuration push.
Set to "1" to restart the controller after a full database push.
Default "0" disables automatic restart.
Page 275
Nucleus Router Control Modules 14.5
Addresses
Source 0 to 1151
Destination 576 to 1151
Destination 1292 to 1339
&
Destination 1364 to 1411
Destination 16370 to 16373
© 2017 SAM