Sam Sirius 840 User Manual page 194

Sirius 800 Series User Manual
LED Color Label
Blue/Green
Table 47
Iss 5 Rev 7
5949 Video Embedding & AHP Output with Delay & Sync
Detail
Local Receiving messages
Command from local Nucleus
Yellow OK control module (the
Nucleus controller in
this frame)
Local Error with messages
Command from local Nucleus
Error control module (the
Nucleus controller in
this frame)
Red
Remote Receiving messages
Command from remote Nucleus
OK control module (the
Yellow
Nucleus controller in the
frame linked to this
frame)
Remote Error with messages
Error from remote Nucleus
control module (the
Nucleus controller in the
frame linked to this
frame)
Red
Fugue CPU status
Status
5949 Output Module LED Information (Continued)
Normal Working Status
Flashing - receiving information and
working correctly
Off - normal state
Flashing - the command message from
the router controller is corrupt or hasn't
been received.
This communications error could be
caused by a hardware failure or incorrect
insertion. Check that the module is
inserted correctly.
If the "Local Command Error" LED is
flashing at the same time as the "Local
Command OK" LED is flashing it suggests
a mismatch in the configuration of the
Nucleus controller. Check controller
configuration.
Sirius 830/840/850 (no expansion):
Off - Expansion not used.
Sirius 850 (expanded to second frame):
Flashing - receiving information and
working correctly
Sirius 830/840/850 (no expansion):
Off - Expansion not used.
Sirius 850 (expanded to second frame):
Off - normal state,
Flashing - the command message from
the remote router controller is corrupt or
hasn't been received.
This communications error could be
caused by a hardware failure or incorrect
insertion. Check that the module is
inserted correctly and the four RJ45
connections between the frames are fitted
correctly (see section 12.2).
If the "Remote Error" LED is flashing at
the same time as the "Remote Command
OK" LED is flashing it suggests a
mismatch in the configuration of the
Nucleus controller. Check controller
configuration.
Flashing sequence Green, Green, Blue
- normal operation the CPU is
programmed and running
Brief Red Flash at startup - normal
Flashing Red - CPU Error. Remove
module and refit to force a reboot.
Page 194
Output Modules and Rear Panels 11.3
© 2017 SAM