Sam Sirius 840 User Manual page 316

Sirius 800 Series User Manual
C.2.2.6 5915 Input Module LED Information
Table 97 shows the LED color code on the 5915 Input Module, and Figure 202 shows the
front edge of the input module.
LED Color Label
Table 97
Iss 5 Rev 7
Detail
Red
1
Green
Red
2
Green
Red
3
Green
Red
4
Green
Green Power OK Power to the module
Local Receiving messages
Command from local Nucleus
Yellow OK control module (the
Nucleus controller in
this frame)
Local Error Error with messages
from local Nucleus
control module (the
Nucleus controller in
this frame)
Red
5915 Sirius 800 Video AHP Input Module LED Information
Input Modules Modules No Longer Supplied With New Systems C.2
Normal Working Status
Each Pair of FPGA LEDS:
Flashing rapidly between Red & Green
FPGA 1 status
(2 Hz each LED) - starting up
Green On Solid & Red Off - normal state
working correctly
Green Off & Red On Solid - FPGA
programming fault found. Remove module
and refit to force a reboot.
FPGA 2 status
Red & Green Flashing very rapidly in
sync (4 Hz each LED) - A change has
been made to the module settings
database in RAM but it has not yet been
written to flash memory. This is not a fault
and the flash memory will be updated after
FPGA 3 status 10 seconds of no audio setting changes
being made. Do not remove power from
the module while this indication is present
as the flash may become corrupted.
Other indications are displayed when
performing a firmware upgrade, see the
FPGA 4 status
Sirius 800 Maintenance & Upgrade
manual for details.
On Solid - working correctly
Flashing - receiving information and
working correctly
Off - normal state
Flashing - the command message from
the router controller is corrupt or hasn't
been received.
This communications error could be
caused by a hardware failure or incorrect
insertion. Check that the module is
inserted correctly.
If the "Local Error" LED is flashing at the
same time as the "Local Command OK"
LED is flashing it suggests a mismatch in
the configuration of the Nucleus controller.
Check the controller configuration.
Page 316 © 2017 SAM