Cruise Control; Cruise Control Linkage - Kubota B2650HSDC Workshop Manual

B2650HSDC, B3350HSDC, WSM

4. CRUISE CONTROL

[1] CRUISE CONTROL LINKAGE

(1) Cruise Control
Cruise control system mainly consists of cruise control lever holding section and cruise control releasing section.
When the cruise control lever (1) is set to the desired position, the bottom end of the cruise link lever (2) turns
clockwise.
The control lever (1) pulls the cruise rear rod (3). The cruise rear rod (3) pulls the cruise front rod (4). The cruise
front rod (4) pulls the neutral holder (5). The HST plate (6) is pulled by the cruise front rod (4).
Since the neutral holder (5) turns clockwise, the trunnion shaft (7) directly attached to the neutral holder (5) turns
clockwise. On the other hand, since the HST plate (6) pulls the HST lever (8) and the HST pedal (9). The HST pedal
(9) is turned to the front side.
On the other hand, since release lever (10) engage with tooth of lever guide RH, the cruise control lever (1) is
held at the desired cruise position until the brake pedals will be depressed by an operator.
2-M14
TRANSMISSION
(1) Cruise Control Lever
(2) Cruise Link Lever
(3) Cruise Rear Rod
(4) Cruise Front Rod
(5) Neutral Holder
(6) HST Plate
(7) Trunnion Shaft
(8) HST Lever
(9) HST Pedal
(10) Release Lever
9Y1210822TRM0011US0
KiSC issued 05, 2014 A