Table of Contents
Advertisement
Auto-Exposure Enable: This mode will automatically adjust the integration period such that, if possible,
the resulting histogram fills about 80% of the dynamic range.
Save Settings: After using the FLIR Camera Controller GUI to change Camera modes and settings to
desired values, use the Save Settings button to store many of the current selections as new power-up
defaults. The next time the camera is powered; the camera will remember these saved settings. If the Save
Settings button is not clicked, any changes made via the FLIR Camera Controller GUI will be valid only
for the current session. Cycling power to the camera will revert to the previously saved settings.
Note: The Save Settings button applies to changes made anywhere in the GUI, not only the Setup
Tab.
Factory Defaults: The Factory Defaults button restores the camera's settings to the initial values specified
by FLIR. To save the factory default settings as the power up defaults, first click the Factory Defaults
button, then click the Save Settings button.
Reset Camera: The Reset Camera button performs a soft reset that restarts the camera software.
Page 42
The information contained in this document pertains to a dual use product controlled for export by the Export Administration
Regulations (EAR). Diversion contrary to US law is prohibited. US Department of Commerce authorization is not required prior to
export or transfer to foreign persons or parties unless otherwise prohibited.
Advertisement
Table of Contents
