W&T 57630 Manual page 99

W&T
Interval
If you want to send the state of the inputs cyclically to the
communications partner, the interval can be entered here in 100ms
increments.
Example: The value 300 corresponds to 30 seconds.
1
Please note that when using charged dial-up
connections, too short an interval can result in this
connection remaining open while charges continue to
accumulate!
Application Mode
In UDP peer configuration, there is no difference between the
Default and Compatible 50xxx modes.
Once you have made all your settings, send them to the Web-IO
by clicking on the Temporary Storage button.
In addition you must enable the corresponding inputs for binary
mode.
Under Config >> Device >> Output Mode select the desired binary
access.
m
Required access rights: Administrator
Once you have made all your entries, send the setting to the
Web-IO by cliking on the Logout button. Clicking on the Save
button activates the settings.
Subject to errors and modifications:
TCP / UDP - Binary
99