W&T
error;xxxx
where xxxx is the hex value for the output which was turned
off.
Example:
error;0001
In this case Output 0 is affected.
To turn on the affected outputs again, the application program
sends
GET /errorclear?PW=password&
to the Web-IO.
Now if there is no longer an overload condition, the Web-IO
resumes as normal on all outputs.
1
Please note that the GET HEADER ENABLE setting under
Config >> Device Basic Settings >> HTTP also precedes
the Error and Diag messages with a header. The 0 character is
still appended for error messages.
90
Controlling the Web-IO with TCP/UDP Sockets