W&T 57630 Manual page 177

W&T
Ports - Input- and output configuration
Outputs that are combined in a group should be configured for
the same operation mode. Otherwise conflicts can arise if for
example Outputs 0 and 1 are in Box-to-Box nmode and Outputs
2 and 3 can be switched from the browser, since each access
switches all the outputs in a group at the same time.
An overview of the configured output groups can be found under
Config >> Device >> Output Mode.
m
Required access rights: Administrator
Here the outputs that are combined in a group are highlighted
in the same color.
In the example shown, Outputs 0 - 3 represent a group. Outputs 4
and 5 and Outputs 6 and 7 represent two additional groups.
Outputs 8,9,10 and 11 are ungrouped, and can be switched
individually.
An additional way to see the groups at a glance is under Diag
>> Test >> Output Config in the column Group Mode.
m
Required access rights: Administrator
Subject to errors and modifications: 177