W&T
Controlling the Web-IO with TCP/UDP Sockets
In the Port field enter the desired local port. The factory setting
is Port 42279. Check UDP enable.
Click on the Temporary Storage button to pass the selected
settings to the Web-IO.
You must also specify which of the 12 outputs you want to make
available for access via UDP using command strings.
Select in the navigation tree Config >> Device >> Output Mode.
m
Required access rights: Administrator
All the outputs used must be activated for UDP ASCII.
If you have changed the output modes, click on the Temporary
Storage button and then on the Save and activate all temporary
settings link. Clicking on the Save button saves all your settings.
82