W&T 57630 Manual page 176

W&T
Ports - Input- and output configuration
Name
Enter here a name for the input. This name will then be
displayed in the browser for Output 0.
Text
Here you can provide a more detailed description, including for
example the function of the output, which can then be viewed by
clicking on the Output link in the browser.
Group Mode
The outputs can be combined into groups of two or four to
increase the maximum switching current. Combining two outputs
allows you to switch a maximum current of 1A. With four
outputs this increases to 2A.
Safety State
Select Safety State Enable if you want the output to be set to a
fixed state when there is a fault. Specify whether the output shall
be switched to the ON or OFF state.
This will only have an effect if a time is selected for Safety Time-
out in Config >> Device >> Output Mode
A detailed description of Safety State can be found in the
section Safety Timeout / State.
Send the settings to the Web-IO by clicking on the Temporary
Storage button.
Once you have made all the entries pertaining to the alarm,
a c t i v a t e t h e n e w s e t t i n g s u n d e r C o n f i g > > S e s s i o n
Control >> LogOut, Save.
176