W&T 57630 Manual page 191

W&T
When Load Control is activated an overload or the absence
of a load is detected.
In case of overload the Web-IO turns the output off.
i
Since the latter case may represent a serious
error, these fields are highlighted in red.
Load Control
In addition to the thermal short circuit protection, the Web-IO
12xDigital has load monitoring which in case of error turns the
outputs off until they are enabled again by the Administrator.
The factory default setting is for Load Control not activated.
Under Config >> Device >> Output Mode you can activate or
deactivate load monitoring by selecting Load Control Enable.
m Required access rights: Administrator
Subject to errors and modifications:
Diacnostics and testing
191