Laser Safety Precautions; Light Intensity Hazard Distance - Christie Mirage HD25 User Manual
Crimson series
Hide thumbs
Also See for Mirage HD25:
- Service manual (98 pages) ,
- User manual (65 pages) ,
- Installation and setup manual (59 pages)
Table of Contents
Advertisement
Caution! If not avoided, the following could result in minor or moderate injury.
•
FIRE HAZARD! Do not use a power cord, harness, or cable that appears damaged.
•
FIRE OR SHOCK HAZARD! Do not overload power outlets and extension cords.
•
SHOCK HAZARD! Power supply uses double pole/neutral fusing.
Laser safety precautions
Read all safety and warning guidelines before operating the projector laser.
Warning! If not avoided, the following could result in death or serious injury.
•
LASER RADIATION HAZARD! This projector has a built-in Class 4 laser module. Never attempt to
disassemble or modify the laser module.
•
Possibly hazardous optical radiation emitted from this product. (Risk group 3)
•
Only Christie qualified technicians who are knowledgeable about the hazards associated with
laser use, high-voltage, and high temperatures generated by the product are authorized to
assemble, install, and service the Christie Laser Projection System.
•
Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage.
•
Do not operate the product without all of its covers in place.
Light intensity hazard distance
This projector has been classified as Risk Group 3 as per the IEC 62471:2006 standard due to possible
hazardous optical and thermal radiation being emitted.
Warning! If not avoided, the following could result in serious injury.
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! No direct exposure to the beam must be
permitted. Class 1 Laser Product - Risk Group 3 according to IEC 60825-1:2014 and IEC
62471:2006
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! Operators must control access to the beam
within the hazard distance or install the product at the height that prevents exposure of
spectators' eyes within the hazard distance. The hazard zone must be no lower than 3.0 meters
above the floor and the horizontal clearance to the hazard zone must be a minimum 2.5 meters.
•
EXTREME BRIGHTNESS! Do not place reflective objects in the product light path.
The following diagram and table show the zones for ocular and skin hazard distances:
Crimson User Guide–Mirage HD25, Mirage WU25, Crimson HD25, Crimson WU25
020-102649-01 Rev. 1 (04-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Introduction
9
Advertisement
Table of Contents
